Fisher & Paykel Fisher and dish drawer Error Code F1: Meaning & How to Fix It

By the ErrorCodePro Editorial Team · Last reviewed October 20, 2026

Fisher & Paykel Fisher and dish drawer error code F1 means: Water leak detected. [1] Keep using it? No. Stop using it until the cause is fixed. Start with the owner checks below, beginning with: write down the code and model number.

Source: Fisher and Paykel dish drawer error-code chart, via Sears PartsDirect [1].

Quick facts

Code	F1
Also shown as	None listed by the manufacturer
Brand / appliance	Fisher & Paykel Fisher and dish drawer
System	Leak protection
Meaning (service chart)	Water leak detected. [1]
Keep using it?	No. Stop using it until the cause is fixed
DIY-safe?	Owner checks only (listed below)
Support	Fisher & Paykel customer support (see your owner's manual)
Source document	Fisher and Paykel dish drawer error-code chart (via Sears PartsDirect)

On this page: Meaning · Steps · Parts · When to call a technician · Related codes · FAQ

What error code F1 means on a Fisher & Paykel Fisher and dish drawer

Water leak detected. [1]

This is a leak protection code. Codes and wording can vary by model, so check your owner's manual for your model number.

How to fix Fisher & Paykel Fisher and dish drawer error code F1 (safe owner checks)

Safety first: disconnect power before you remove any panel or reach into the sump or drum. Do not touch wiring, the control board or the motor. If you see water near electrical parts, stop and call a technician. These steps are based on the Fisher and Paykel dish drawer error-code chart (via Sears PartsDirect) [1], rewritten for clarity.

Write down the code and model number. Note exactly what the display shows (F1) and copy the full model number from the rating label, so you can confirm this chart applies to your fisher and dish drawer and order the right parts.
Shut off power. Shut off power to the dishwasher and remove the drawer(s).
Close the door or lid fully. Check the lid seal, hoses and heater plate seal for leaks.
Test and decide. Run a short cycle or restart and watch the display. If F1 comes back after these checks, stop using the dishwasher for this function and call a technician, because the remaining causes need meters or part replacement.

The first and last steps (and the power reset) are general owner checks added by ErrorCodePro; the rest follow the Fisher and Paykel dish drawer error-code chart published by Sears PartsDirect, rewritten for safe owner use.

Parts that may be involved

Exact parts depend on your model number. This page lists part types only, never part numbers.

Lid seal
Hoses
Heater plate seal

When to call a technician

Technician: replace any leaking components.
Anything involving wiring, the control board, the motor or the water valve electrics
The appliance is under warranty: contact Fisher & Paykel customer support (see your owner's manual) first

Frequently asked questions

What does error code F1 mean on a Fisher & Paykel Fisher and dish drawer?

The Fisher and Paykel dish drawer error-code chart lists F1 as follows: Water leak detected.

Is it safe to keep using the Fisher and dish drawer with F1?

No. Stop using it until the cause is fixed.

Can I fix Fisher & Paykel Fisher and dish drawer error F1 myself?

Only with the owner checks on this page, starting with: write down the code and model number. If it persists, call a technician or Fisher & Paykel customer support (see your owner's manual).

Sources

Sears PartsDirect: Fisher and Paykel dish drawer error-code chart (third-party copy of manufacturer service data)

Last reviewed: October 20, 2026. ErrorCodePro is not affiliated with Fisher & Paykel.