GE Front-load washer Error Code E30: Meaning & How to Fix It

By the ErrorCodePro Editorial Team · Last reviewed October 20, 2026

GE front-load washer error code E30 means: No drain. [1] Keep using it? Only if the owner checks below clear the code; if it returns, stop and book a repair. Start with the owner checks below, beginning with: write down the code and model number.

Source: GE front-load washer error-code chart, via Sears PartsDirect [1].

Quick facts

Code	E30
Also shown as	None listed by the manufacturer
Brand / appliance	GE front-load washer
System	Drain
Meaning (service chart)	No drain. [1]
Keep using it?	Only if the owner checks below clear the code; if it returns, stop and book a repair
DIY-safe?	Owner checks only (listed below)
Support	GE Appliances support (products.geappliances.com)
Source document	GE front-load washer error-code chart (via Sears PartsDirect)

On this page: Meaning · Steps · Parts · When to call a technician · Related codes · FAQ

What error code E30 means on a GE front-load washer

No drain. [1]

This is a drain code. Codes and wording can vary by model, so check your owner's manual for your model number.

How to fix GE front-load washer error code E30 (safe owner checks)

Safety first: disconnect power before you remove any panel or reach into the sump or drum. Do not touch wiring, the control board or the motor. If you see water near electrical parts, stop and call a technician. These steps are based on the GE front-load washer error-code chart (via Sears PartsDirect) [1], rewritten for clarity.

Write down the code and model number. Note exactly what the display shows (E30) and copy the full model number from the rating label, so you can confirm this chart applies to your front-load washer and order the right parts.
Fix the detergent dose. Remove excess suds; the washer can't drain excessively sudsy water.
Clean the filter. Unplug the washer and check the large-item filter in the drain pump for a clog.
Test and decide. Run a short cycle or restart and watch the display. If E30 comes back after these checks, stop using the washer for this function and call a technician, because the remaining causes need meters or part replacement.

The first and last steps (and the power reset) are general owner checks added by ErrorCodePro; the rest follow the GE front-load washer error-code chart published by Sears PartsDirect, rewritten for safe owner use.

Parts that may be involved

Exact parts depend on your model number. This page lists part types only, never part numbers.

Drain pump

When to call a technician

If the drain pump is defective, a technician should replace it.
Anything involving wiring, the control board, the motor or the water valve electrics
The appliance is under warranty: contact GE Appliances support (products.geappliances.com) first

Frequently asked questions

What does error code E30 mean on a GE front-load washer?

The GE front-load washer error-code chart lists E30 as follows: No drain.

Is it safe to keep using the front-load washer with E30?

Only if the owner checks below clear the code; if it returns, stop and book a repair.

Can I fix GE front-load washer error E30 myself?

Only with the owner checks on this page, starting with: write down the code and model number. If it persists, call a technician or GE Appliances support (products.geappliances.com).

Sources

Sears PartsDirect: GE front-load washer error-code chart (third-party copy of manufacturer service data)

Last reviewed: October 20, 2026. ErrorCodePro is not affiliated with GE.