Jenn-Air MicroClean HE dishwasher Error Code F6E3: Meaning & How to Fix It

By the ErrorCodePro Editorial Team · Last reviewed October 20, 2026

Jenn-Air MicroClean HE dishwasher error code F6E3 means: Suds or air are in the water pump. The drain pump will run for 3 minutes. The water level should just touch the bottom of the overfill float mushroom. [1] Keep using it? Only if the owner checks below clear the code; if it returns, stop and book a repair. Start with the owner checks below, beginning with: write down the code and model number.

Source: Jenn-Air MicroClean HE dishwasher error-code chart, via Sears PartsDirect [1].

Quick facts

Code	F6E3
Also shown as	6-3
Brand / appliance	Jenn-Air MicroClean HE dishwasher
System	Suds / detergent
Meaning (service chart)	Suds or air are in the water pump. The drain pump will run for 3 minutes. The water level should just touch the bottom of the overfill float mushroom. [1]
Keep using it?	Only if the owner checks below clear the code; if it returns, stop and book a repair
DIY-safe?	Owner checks only (listed below)
Support	Jenn-Air customer support (see your owner's manual)
Source document	Jenn-Air MicroClean HE dishwasher error-code chart (via Sears PartsDirect)

On this page: Meaning · Steps · Parts · When to call a technician · Related codes · FAQ

What error code F6E3 means on a Jenn-Air MicroClean HE dishwasher

Suds or air are in the water pump. The drain pump will run for 3 minutes. The water level should just touch the bottom of the overfill float mushroom. [1]

This is a suds / detergent code. Codes and wording can vary by model, so check your owner's manual for your model number.

How to fix Jenn-Air MicroClean HE dishwasher error code F6E3 (safe owner checks)

Safety first: disconnect power before you remove any panel or reach into the sump or drum. Do not touch wiring, the control board or the motor. If you see water near electrical parts, stop and call a technician. These steps are based on the Jenn-Air MicroClean HE dishwasher error-code chart (via Sears PartsDirect) [1], rewritten for clarity.

Write down the code and model number. Note exactly what the display shows (F6E3) and copy the full model number from the rating label, so you can confirm this chart applies to your microClean HE dishwasher and order the right parts.
Fix the detergent dose. Check for sudsy water. Use only dishwasher detergent in the dishwasher.
Level the appliance. Load items so they don't flip over during the cycle and cause low water level.
Open the water supply. Unplug the dishwasher to disconnect electrical power and close the water supply valve. Disconnect the water supply line from the water inlet valve and check the water inlet valve screen for clogs.
Test and decide. Run a short cycle or restart and watch the display. If F6E3 comes back after these checks, stop using the dishwasher for this function and call a technician, because the remaining causes need meters or part replacement.

The first and last steps (and the power reset) are general owner checks added by ErrorCodePro; the rest follow the Jenn-Air MicroClean HE dishwasher error-code chart published by Sears PartsDirect, rewritten for safe owner use.

Parts that may be involved

Exact parts depend on your model number. This page lists part types only, never part numbers.

Water inlet valve
Detergent dispenser
Wire harness

When to call a technician

Technician: check the detergent dispenser and replace if it's damaged.
Technician: replace the water valve if you find the screen clogged because debris from the clog can get into the valve body, causing the valve to stick open and possibly flood your kitchen.
If the water flows okay, a technician should check the wiring connections on the water inlet valve and reconnect any loose wires or replace the wire harness if damaged.
If the wires are okay, you may need to replace the water inlet valve.
Anything involving wiring, the control board, the motor or the water valve electrics
The appliance is under warranty: contact Jenn-Air customer support (see your owner's manual) first

Frequently asked questions

What does error code F6E3 mean on a Jenn-Air MicroClean HE dishwasher?

The Jenn-Air MicroClean HE dishwasher error-code chart lists F6E3 as follows: Suds or air are in the water pump. The drain pump will run for 3 minutes. The water level should just touch the bottom of the overfill float mushroom.

Is it safe to keep using the MicroClean HE dishwasher with F6E3?

Only if the owner checks below clear the code; if it returns, stop and book a repair.

Can I fix Jenn-Air MicroClean HE dishwasher error F6E3 myself?

Only with the owner checks on this page, starting with: write down the code and model number. If it persists, call a technician or Jenn-Air customer support (see your owner's manual).

Is 6-3 the same as F6E3?

Yes. The source chart lists 6-3 with the same meaning as F6E3; the display format depends on the model.

Sources

Sears PartsDirect: Jenn-Air MicroClean HE dishwasher error-code chart (third-party copy of manufacturer service data)

Last reviewed: October 20, 2026. ErrorCodePro is not affiliated with Jenn-Air.