ErrorCodePro · Appliance Error CodesLG Pedestal washer Error Code dE1: Meaning & How to Fix It
By the ErrorCodePro Editorial Team · Last reviewed October 20, 2026
LG pedestal washer error code dE1 means: Drawer is not closed properly. [1] Keep using it? Only if the owner checks below clear the code; if it returns, stop and book a repair. Start with the owner checks below, beginning with: write down the code and model number.
Source: LG pedestal washer error-code chart, via Sears PartsDirect [1].
Quick facts
| Code | dE1 |
|---|---|
| Also shown as | dE2 |
| Brand / appliance | LG pedestal washer |
| System | Control / electronics |
| Meaning (service chart) | Drawer is not closed properly. [1] |
| Keep using it? | Only if the owner checks below clear the code; if it returns, stop and book a repair |
| DIY-safe? | Owner checks only (listed below) |
| Support | LG USA Support (lg.com/us/support) |
| Source document | LG pedestal washer error-code chart (via Sears PartsDirect) |
On this page: Meaning · Steps · Parts · When to call a technician · Related codes · FAQ
What error code dE1 means on an LG pedestal washer
Drawer is not closed properly. [1]
This is a control / electronics code. Codes and wording can vary by model, so check your owner's manual for your model number.
How to fix LG pedestal washer error code dE1 (safe owner checks)
- Write down the code and model number. Note exactly what the display shows (dE1) and copy the full model number from the rating label, so you can confirm this chart applies to your pedestal washer and order the right parts.
- Clear the code at the controls. Close the drawer completely and start the cycle.
- Do a power reset. Unplug the appliance or switch off its breaker for one minute, then restore power and try again. If the code clears and stays away, it may have been a one-off fault.
- Test and decide. Run a short cycle or restart and watch the display. If dE1 comes back after these checks, stop using the washer for this function and call a technician, because the remaining causes need meters or part replacement.
The first and last steps (and the power reset) are general owner checks added by ErrorCodePro; the rest follow the LG pedestal washer error-code chart published by Sears PartsDirect, rewritten for safe owner use.
Parts that may be involved
Exact parts depend on your model number. This page lists part types only, never part numbers.
- Drawer switch
- Wire harness
When to call a technician
- If the drawer closes properly, unplug the washer and check the wire harness connections between the electronic control board and the drawer switch.
- Reconnect any loose wires or replace the wire harness if damaged.
- If the wire connections are okay, a technician should replace the drawer switch.
- Anything involving wiring, the control board, the motor or the water valve electrics
- The appliance is under warranty: contact LG USA Support (lg.com/us/support) first
Related error codes
Frequently asked questions
What does error code dE1 mean on an LG pedestal washer?
The LG pedestal washer error-code chart lists dE1 as follows: Drawer is not closed properly.
Is it safe to keep using the pedestal washer with dE1?
Only if the owner checks below clear the code; if it returns, stop and book a repair.
Can I fix LG pedestal washer error dE1 myself?
Only with the owner checks on this page, starting with: write down the code and model number. If it persists, call a technician or LG USA Support (lg.com/us/support).
Is dE2 the same as dE1?
Yes. The source chart lists dE2 with the same meaning as dE1; the display format depends on the model.
Sources
- Sears PartsDirect: LG pedestal washer error-code chart (third-party copy of manufacturer service data)
Last reviewed: October 20, 2026. ErrorCodePro is not affiliated with LG.