Whirlpool 2015 Cabrio dryer Error Code F4 E3: Meaning & How to Fix It

By the ErrorCodePro Editorial Team · Last reviewed October 20, 2026

Whirlpool 2015 Cabrio dryer error code F4 E3 means: Airflow restriction. [1] Keep using it? Only if the owner checks below clear the code; if it returns, stop and book a repair. Start with the owner checks below, beginning with: write down the code and model number.

Source: Whirlpool 2015 Cabrio dryer error-code chart, via Sears PartsDirect [1].

Quick facts

Code	F4 E3
Also shown as	None listed by the manufacturer
Brand / appliance	Whirlpool 2015 Cabrio dryer
System	Venting / airflow
Meaning (service chart)	Airflow restriction. [1]
Keep using it?	Only if the owner checks below clear the code; if it returns, stop and book a repair
DIY-safe?	Owner checks only (listed below)
Support	Whirlpool: 1-866-698-2538
Source document	Whirlpool 2015 Cabrio dryer error-code chart (via Sears PartsDirect)

On this page: Meaning · Steps · Parts · When to call a technician · Related codes · FAQ

What error code F4 E3 means on a Whirlpool 2015 Cabrio dryer

Airflow restriction. [1]

This is a venting / airflow code. Codes and wording can vary by model, so check your owner's manual for your model number.

How to fix Whirlpool 2015 Cabrio dryer error code F4 E3 (safe owner checks)

Safety first: disconnect power before you remove any panel or reach into the sump or drum. Do not touch wiring, the control board or the motor. If you see water near electrical parts, stop and call a technician. These steps are based on the Whirlpool 2015 Cabrio dryer error-code chart (via Sears PartsDirect) [1], rewritten for clarity.

Write down the code and model number. Note exactly what the display shows (F4 E3) and copy the full model number from the rating label, so you can confirm this chart applies to your 2015 Cabrio dryer and order the right parts.
Clean the lint screen. Clean the lint screen.
Straighten kinked hoses. Check the flexible vent hose behind the dryer for kinks or clogs.
Check the vent. Clean the duct system that vents dryer air to the outside of your home. Make sure that the damper vent on the outside of your home opens properly.
Do a power reset. Unplug the appliance or switch off its breaker for one minute, then restore power and try again. If the code clears and stays away, it may have been a one-off fault.
Test and decide. Run a short cycle or restart and watch the display. If F4 E3 comes back after these checks, stop using the dryer for this function and call a technician, because the remaining causes need meters or part replacement.

The first and last steps (and the power reset) are general owner checks added by ErrorCodePro; the rest follow the Whirlpool 2015 Cabrio dryer error-code chart published by Sears PartsDirect, rewritten for safe owner use.

Parts that may be involved

Exact parts depend on your model number. This page lists part types only, never part numbers.

No specific part is implied by the manufacturer's guidance for this code.

When to call a technician

Anything involving wiring, the control board, the motor or the water valve electrics
The appliance is under warranty: contact Whirlpool: 1-866-698-2538 first

Frequently asked questions

What does error code F4 E3 mean on a Whirlpool 2015 Cabrio dryer?

The Whirlpool 2015 Cabrio dryer error-code chart lists F4 E3 as follows: Airflow restriction.

Is it safe to keep using the 2015 Cabrio dryer with F4 E3?

Only if the owner checks below clear the code; if it returns, stop and book a repair.

Can I fix Whirlpool 2015 Cabrio dryer error F4 E3 myself?

Only with the owner checks on this page, starting with: write down the code and model number. If it persists, call a technician or Whirlpool: 1-866-698-2538.

Sources

Sears PartsDirect: Whirlpool 2015 Cabrio dryer error-code chart (third-party copy of manufacturer service data)

Last reviewed: October 20, 2026. ErrorCodePro is not affiliated with Whirlpool.