GE GFW front-load washer Error Code 27: Meaning & How to Fix It

By the ErrorCodePro Editorial Team · Last reviewed October 20, 2026

GE GFW front-load washer error code 27 means: Door has been open more than 15 minutes with water in the tub. [1] Keep using it? Only if the owner checks below clear the code; if it returns, stop and book a repair. Start with the owner checks below, beginning with: write down the code and model number.

Source: GE GFW front-load washer error-code chart, via Sears PartsDirect [1].

Quick facts

Code	27
Also shown as	None listed by the manufacturer
Brand / appliance	GE GFW front-load washer
System	Door / lock
Meaning (service chart)	Door has been open more than 15 minutes with water in the tub. [1]
Keep using it?	Only if the owner checks below clear the code; if it returns, stop and book a repair
DIY-safe?	Owner checks only (listed below)
Support	GE Appliances support (products.geappliances.com)
Source document	GE GFW front-load washer error-code chart (via Sears PartsDirect)

On this page: Meaning · Steps · Parts · When to call a technician · Related codes · FAQ

What error code 27 means on a GE GFW front-load washer

Door has been open more than 15 minutes with water in the tub. [1]

This is a door / lock code. Codes and wording can vary by model, so check your owner's manual for your model number.

How to fix GE GFW front-load washer error code 27 (safe owner checks)

Safety first: disconnect power before you remove any panel or reach into the sump or drum. Do not touch wiring, the control board or the motor. If you see water near electrical parts, stop and call a technician. These steps are based on the GE GFW front-load washer error-code chart (via Sears PartsDirect) [1], rewritten for clarity.

Write down the code and model number. Note exactly what the display shows (27) and copy the full model number from the rating label, so you can confirm this chart applies to your GFW front-load washer and order the right parts.
Check the settings. Use the rinse, drain and spin cycle to remove water after running a cycle with the No Spin option selected.
Reconnect the air hose. Reconnect the air hose if it’s loose.
Do a power reset. Unplug the appliance or switch off its breaker for one minute, then restore power and try again. If the code clears and stays away, it may have been a one-off fault.
Test and decide. Run a short cycle or restart and watch the display. If 27 comes back after these checks, stop using the washer for this function and call a technician, because the remaining causes need meters or part replacement.

The first and last steps (and the power reset) are general owner checks added by ErrorCodePro; the rest follow the GE GFW front-load washer error-code chart published by Sears PartsDirect, rewritten for safe owner use.

Parts that may be involved

Exact parts depend on your model number. This page lists part types only, never part numbers.

Electronic control board

When to call a technician

Unplug the washer and check the air hose between the bottom of the tub and the connection on the electronic control board.
Technician: replace the air hose if it’s pinched, punctured or damaged.
If the air hose is okay, a technician should replace the electronic control board (the water level sensor is a component of the electronic control board).
Anything involving wiring, the control board, the motor or the water valve electrics
The appliance is under warranty: contact GE Appliances support (products.geappliances.com) first

Frequently asked questions

What does error code 27 mean on a GE GFW front-load washer?

The GE GFW front-load washer error-code chart lists 27 as follows: Door has been open more than 15 minutes with water in the tub.

Is it safe to keep using the GFW front-load washer with 27?

Only if the owner checks below clear the code; if it returns, stop and book a repair.

Can I fix GE GFW front-load washer error 27 myself?

Only with the owner checks on this page, starting with: write down the code and model number. If it persists, call a technician or GE Appliances support (products.geappliances.com).

Sources

Sears PartsDirect: GE GFW front-load washer error-code chart (third-party copy of manufacturer service data)

Last reviewed: October 20, 2026. ErrorCodePro is not affiliated with GE.