Haier Front-load washer Error Code no tAPS: Meaning & How to Fix It

By the ErrorCodePro Editorial Team · Last reviewed October 20, 2026

Haier front-load washer error code no tAPS means: Not filling. [1] Keep using it? Only if the owner checks below clear the code; if it returns, stop and book a repair. Start with the owner checks below, beginning with: write down the code and model number.

Source: Haier front-load washer error-code chart, via Sears PartsDirect [1].

Quick facts

Code	no tAPS
Also shown as	None listed by the manufacturer
Brand / appliance	Haier front-load washer
System	Water fill
Meaning (service chart)	Not filling. [1]
Keep using it?	Only if the owner checks below clear the code; if it returns, stop and book a repair
DIY-safe?	Owner checks only (listed below)
Support	Haier customer support (see your owner's manual)
Source document	Haier front-load washer error-code chart (via Sears PartsDirect)

On this page: Meaning · Steps · Parts · When to call a technician · Related codes · FAQ

What error code no tAPS means on a Haier front-load washer

Not filling. [1]

This is a water fill code. Codes and wording can vary by model, so check your owner's manual for your model number.

How to fix Haier front-load washer error code no tAPS (safe owner checks)

Safety first: disconnect power before you remove any panel or reach into the sump or drum. Do not touch wiring, the control board or the motor. If you see water near electrical parts, stop and call a technician. These steps are based on the Haier front-load washer error-code chart (via Sears PartsDirect) [1], rewritten for clarity.

Write down the code and model number. Note exactly what the display shows (no tAPS) and copy the full model number from the rating label, so you can confirm this chart applies to your front-load washer and order the right parts.
Check the drain system. Check the drain system for a siphon problem.
Do a power reset. Unplug the appliance or switch off its breaker for one minute, then restore power and try again. If the code clears and stays away, it may have been a one-off fault.
Test and decide. Run a short cycle or restart and watch the display. If no tAPS comes back after these checks, stop using the washer for this function and call a technician, because the remaining causes need meters or part replacement.

The first and last steps (and the power reset) are general owner checks added by ErrorCodePro; the rest follow the Haier front-load washer error-code chart published by Sears PartsDirect, rewritten for safe owner use.

Parts that may be involved

Exact parts depend on your model number. This page lists part types only, never part numbers.

Water inlet valve assembly

When to call a technician

If the water inlet valve assembly is defective, a technician should replace it.
Anything involving wiring, the control board, the motor or the water valve electrics
The appliance is under warranty: contact Haier customer support (see your owner's manual) first

Frequently asked questions

What does error code no tAPS mean on a Haier front-load washer?

The Haier front-load washer error-code chart lists no tAPS as follows: Not filling.

Is it safe to keep using the front-load washer with no tAPS?

Only if the owner checks below clear the code; if it returns, stop and book a repair.

Can I fix Haier front-load washer error no tAPS myself?

Only with the owner checks on this page, starting with: write down the code and model number. If it persists, call a technician or Haier customer support (see your owner's manual).

Sources

Sears PartsDirect: Haier front-load washer error-code chart (third-party copy of manufacturer service data)

Last reviewed: October 20, 2026. ErrorCodePro is not affiliated with Haier.