ErrorCodePro · Appliance Error Codes

Kenmore 363 electronic control model dishwasher Error Code C8: Meaning & How to Fix It

By the ErrorCodePro Editorial Team · Last reviewed October 20, 2026

Kenmore 363 electronic control model dishwasher error code C8 means: Detergent dispenser cover is blocked. [1] Keep using it? Only if the owner checks below clear the code; if it returns, stop and book a repair. Start with the owner checks below, beginning with: write down the code and model number.

Source: Kenmore 363 electronic control model dishwasher error-code chart, via Sears PartsDirect [1].

Quick facts

CodeC8
Also shown asNone listed by the manufacturer
Brand / applianceKenmore 363 electronic control model dishwasher
SystemSuds / detergent
Meaning (service chart)Detergent dispenser cover is blocked. [1]
Keep using it?Only if the owner checks below clear the code; if it returns, stop and book a repair
DIY-safe?Owner checks only (listed below)
SupportKenmore customer support (kenmore.com) or a Sears-authorized technician
Source documentKenmore 363 electronic control model dishwasher error-code chart (via Sears PartsDirect)

On this page: Meaning · Steps · Parts · When to call a technician · Related codes · FAQ

What error code C8 means on a Kenmore 363 electronic control model dishwasher

Detergent dispenser cover is blocked. [1]

This is a suds / detergent code. Codes and wording can vary by model, so check your owner's manual for your model number.

How to fix Kenmore 363 electronic control model dishwasher error code C8 (safe owner checks)

Safety first: disconnect power before you remove any panel or reach into the sump or drum. Do not touch wiring, the control board or the motor. If you see water near electrical parts, stop and call a technician. These steps are based on the Kenmore 363 electronic control model dishwasher error-code chart (via Sears PartsDirect) [1], rewritten for clarity.
  1. Write down the code and model number. Note exactly what the display shows (C8) and copy the full model number from the rating label, so you can confirm this chart applies to your 363 electronic control model dishwasher and order the right parts.
  2. Clear any clog or debris. Remove the obstruction from the dispenser cover.
  3. Clear the code at the controls. Close the dispenser cover and restart the dishwasher.
  4. Do a power reset. Unplug the appliance or switch off its breaker for one minute, then restore power and try again. If the code clears and stays away, it may have been a one-off fault.
  5. Test and decide. Run a short cycle or restart and watch the display. If C8 comes back after these checks, stop using the dishwasher for this function and call a technician, because the remaining causes need meters or part replacement.

The first and last steps (and the power reset) are general owner checks added by ErrorCodePro; the rest follow the Kenmore 363 electronic control model dishwasher error-code chart published by Sears PartsDirect, rewritten for safe owner use.

Parts that may be involved

Exact parts depend on your model number. This page lists part types only, never part numbers.

When to call a technician

Frequently asked questions

What does error code C8 mean on a Kenmore 363 electronic control model dishwasher?

The Kenmore 363 electronic control model dishwasher error-code chart lists C8 as follows: Detergent dispenser cover is blocked.

Is it safe to keep using the 363 electronic control model dishwasher with C8?

Only if the owner checks below clear the code; if it returns, stop and book a repair.

Can I fix Kenmore 363 electronic control model dishwasher error C8 myself?

Only with the owner checks on this page, starting with: write down the code and model number. If it persists, call a technician or Kenmore customer support (kenmore.com) or a Sears-authorized technician.

Sources

  1. Sears PartsDirect: Kenmore 363 electronic control model dishwasher error-code chart (third-party copy of manufacturer service data)

Last reviewed: October 20, 2026. ErrorCodePro is not affiliated with Kenmore.