Kenmore 796 model top-load washer Error Codes: Full List & Meanings

Every Kenmore 796 model top-load washer error code in the Kenmore 796 model top-load washer error-code chart, as published by Sears PartsDirect, with its meaning. Codes vary by model, so confirm in your owner's manual. Support: Kenmore customer support (kenmore.com) or a Sears-authorized technician.

Codes by system

Water fill

Door / lock

All Kenmore 796 model top-load washer error codes

Codes marked "Reset only" or "Service" have no separate page because the manufacturer publishes no owner fix beyond a reset or a service call.

Code	Meaning	System	Owner action
IE	Washer fills slowly.	Water fill	Owner checks
dE	Lid not closed.	Door / lock	Service
dL	Lid lock failure.	Door / lock	Owner checks
FE	Water level too high. The washer is usually fills continuously because a water valve failed when this code appears. The water inlet valve assembly usually needs to be replaced to fix this problem.	Water fill	Reset only
E6	Clutch error. The control detects a problem with the clutch motor.	Motor / drive	Reset only
uE	Load is out of balance or too small.	Load balance	Reset only
tE	Thermistor error.	Heating	Service
PE	Water level sensor failure.	Water fill	Service
LE	Drive motor thermal overload tripped. A failed drive motor or a restriction in the drive system of the washer causes this code. The winding should measure between 5 and 15 ohms.	Motor / drive	Reset only

Symptoms

Sources

Sears PartsDirect: Kenmore 796 model top-load washer error-code chart (third-party copy of manufacturer service data)

Last reviewed: October 20, 2026. ErrorCodePro is not affiliated with Kenmore.