Kenmore 110 model Oasis top-load washer Error Codes: Full List & Meanings

Every Kenmore 110 model Oasis top-load washer error code in the Kenmore 110 model Oasis top-load washer error-code chart, as published by Sears PartsDirect, with its meaning. Codes vary by model, so confirm in your owner's manual. Support: Kenmore customer support (kenmore.com) or a Sears-authorized technician.

Codes by system

Water fill

Control / electronics

Suds / detergent

Motor / drive

Heating

Drain

All Kenmore 110 model Oasis top-load washer error codes

Codes marked "Reset only" or "Service" have no separate page because the manufacturer publishes no owner fix beyond a reset or a service call.

Code	Meaning	System	Owner action
LF	Long fill. Also: F30	Water fill	Owner checks
Ld	Long drain time. This code is displayed when the water level does not change after the drain pump runs. Also: F32	Drain	Reset only
uL	Unbalanced load. This code is steady on when an unbalanced load is detected and the washer runs a mini-cycle routine to balance the load.	Load balance	Service
oL	Overloaded. The size of the load exceeds the washers capacity. Also: F70	Control / electronics	Owner checks
Sd	Excessive suds. The washer conducts a routine to eliminate the excessive suds. Also: F71	Suds / detergent	Owner checks
lid	Lid not closed or lid not opened between cycles. This code appears if you press start with the lid open. Also: F81	Door / lock	Service
HC	Hot & cold fill hoses are reversed.	Water fill	Owner checks
dL (F80, F82, F84	Lid lock failure. Also: F85)	Door / lock	Reset only
dU	Lid unlock failure. This will usually break the lid lock/switch assembly. Also: F83	Door / lock	Reset only
F01	Main electronic control board failure. The main electronic control board is also called the machine control board. The F1 code indicates that the control board is defective.	Control / electronics	Reset only
F02	User interface failure.	Control / electronics	Reset only
F40	Water temperature thermistor failure. The inlet water temperature thermistor (temperature sensor) is integrated into the inlet water valve assembly.	Heating	Service
F41	Motor RPS failure. The motor RPS (Rotor Position Sensor) detects the speed of the drive motor.	Motor / drive	Service
F44	Heater relay failed.	Heating	Service
F50	Motor stalled. The motor RPS (Rotor Position Sensor) detects no rotation of the drive motor.	Motor / drive	Owner checks
F51	Motor RPS failure. The motor RPS (Rotor Position Sensor) detects the speed of the drive motor.	Motor / drive	Owner checks
F52	Motor stop failure. This is caused by a failure in the main electronic control board. The main electronic control board will usually need to be replaced to fix this failure.	Motor / drive	Service
F53	Motor control over-temperature. The motor control portion of the main electronic control board is overheating. This can be caused by a high current draw through the motor circuit due to excessive friction in the drive system.	Heating	Owner checks
F54	Motor control overcurrent. The motor control portion of the main electronic control board is drawing high current. This can be caused by excessive friction in the drive system.	Motor / drive	Owner checks
F72	Basket re-engagement failure. The basket fails to engage the drive system for the spin mode.	Drain	Owner checks

Symptoms

Sources

Sears PartsDirect: Kenmore 110 model Oasis top-load washer error-code chart (third-party copy of manufacturer service data)

Last reviewed: October 20, 2026. ErrorCodePro is not affiliated with Kenmore.