Whirlpool Top Load Washer Error Codes: Full List & Meanings
Every Whirlpool top load washer error code we have verified against Whirlpool's own support pages, with its official meaning. This list covers top load washers. Codes vary by model, so confirm in your owner's manual. Support: Whirlpool: 1-866-698-2538.
Codes by system
Suds / detergent
Load balance
Water fill
Status / reminder
Drain
Door / lock
Dispenser
Power supply
All Whirlpool top load washer error codes
Codes marked "Reset only" or "Service" have no separate page because the manufacturer publishes no owner fix beyond a reset or a service call.
| Code | Official meaning | System | Owner action |
|---|---|---|---|
| F0E2 | The washer detected too many suds, so the load may not be fully rinsed or spun out. Also: F0 E2 | Suds / detergent | Owner checks |
| F0E3 | The load is too heavy and an overload recovery cycle is running. Also: F0 E3 | Load balance | Owner checks |
| F0E4 | The washer senses the incoming water is too hot. Also: F0 E4 | Water fill | Owner checks |
| F0E5 | The load is unbalanced or too large. Also: F0 E5 | Load balance | Owner checks |
| F0E7 | Clothing was detected while the Clean Washer cycle was being run. Also: F0 E7 | Status / reminder | Owner checks |
| F0E8 | Too much water was left in the washer. Also: F0 E8 | Drain | Owner checks |
| F3E2 | The hot and cold inlet hoses may be on the wrong inlets, or a supply is off. Also: F3 E2 | Water fill | Owner checks |
| F5E2 | The washer can't engage the lid lock, possibly because something is obstructing the lid lock area. Also: F5 E2 | Door / lock | Owner checks |
| F5E4 | The lid is open. Also: F5 E4 | Door / lock | Owner checks |
| F8E1 | The washer isn't detecting the right amount of incoming water. Also: F8 E1, LF | Water fill | Owner checks |
| F8E2 | There is a problem with the bulk dispenser. Also: F8 E2 | Dispenser | Owner checks |
| F8E6 | Depending on the model, either the lid is open during a soak or no hot water was detected. Also: F8 E6 | Water fill | Owner checks |
| F9E1 | The washer is taking too long to drain. Also: F9 E1, drn, Ld | Drain | Owner checks |
| HC | The hot and cold inlet hoses are reversed. The code shows at the end of the cycle. | Water fill | Owner checks |
| LdL | The lid isn't locking. An item in the load may be in the way. Also: dL, dLO | Door / lock | Owner checks |
| LdU | Objects on the lid are stopping it from unlocking. Also: dU | Door / lock | Owner checks |
| Lid | The lid was left open. After 10 minutes the cycle resets and the water drains. | Door / lock | Owner checks |
| OFb | The load is out of balance and the washer couldn't correct it automatically. Also: ofb, uL | Load balance | Owner checks |
| oL | The load is too large. | Load balance | Owner checks |
| PF | A power failure interrupted the cycle. | Power supply | Owner checks |
| Sd | There are too many suds, so the washer is running a suds-reduction routine. Also: 5d, Sud | Suds / detergent | Owner checks |
| F0E0 | Whirlpool's help page for this code gives only a reset (or no detail). It does not publish a meaning. Also: F0 E0 | Control / electronics | Reset only |
| F1E1 | Whirlpool's help page for this code gives only a reset (or no detail). It does not publish a meaning. Also: F1 E1 | Control / electronics | Reset only |
| F1E2 | Whirlpool's help page for this code gives only a reset (or no detail). It does not publish a meaning. Also: F1 E2 | Control / electronics | Reset only |
| F2E1 | Whirlpool's help page for this code gives only a reset (or no detail). It does not publish a meaning. Also: F2 E1 | Control / electronics | Reset only |
| F3E3 | Whirlpool's help page for this code gives only a reset (or no detail). It does not publish a meaning. Also: F3 E3 | Control / electronics | Reset only |
| F5E3 | Whirlpool's help page for this code gives only a reset (or no detail). It does not publish a meaning. Also: F5 E3 | Control / electronics | Reset only |
| F6E1 | Whirlpool's help page for this code gives only a reset (or no detail). It does not publish a meaning. Also: F6 E1 | Control / electronics | Reset only |
| F7E0 | Whirlpool's help page for this code gives only a reset (or no detail). It does not publish a meaning. Also: F7 E0 | Control / electronics | Reset only |
| F7E1 | Whirlpool's help page for this code gives only a reset (or no detail). It does not publish a meaning. Also: F7 E1 | Control / electronics | Reset only |
| F7E5 | Whirlpool's help page for this code gives only a reset (or no detail). It does not publish a meaning. Also: F7 E5 | Control / electronics | Reset only |
| F7E6 | Whirlpool's help page for this code gives only a reset (or no detail). It does not publish a meaning. Also: F7 E6 | Control / electronics | Reset only |
| F8E3 | Whirlpool's help page for this code gives only a reset (or no detail). It does not publish a meaning. Also: F8 E3 | Control / electronics | Reset only |
| F0E9 | Whirlpool lists F0E9 as: unbalanced load (see Whirlpool's balancing guide). Also: F0 E9 | Control / electronics | Service |
| F2E2 | Whirlpool lists F2E2 as: keypad issue. Also: F2 E2 | Control / electronics | Service |
| F2E3 | Whirlpool lists F2E3 as: possible control unit, user interface or wiring issue. Also: F2 E3 | Control / electronics | Service |
| F2E4 | Whirlpool lists F2E4 as: user interface or wiring issue. Also: F2 E4 | Control / electronics | Service |
| F2E5 | Whirlpool lists F2E5 as: user interface or wiring issue. Also: F2 E5 | Control / electronics | Service |
| F3E1 | Whirlpool lists F3E1 as: water level not detected; possible control or wiring issue. Also: F3 E1 | Control / electronics | Service |
| F3E5 | Whirlpool lists F3E5 as: mini dispenser; add detergent manually. Also: F3 E5 | Control / electronics | Service |
| F5E1 | Whirlpool lists F5E1 as: door switch; make sure the lid is fully closed and unobstructed. Also: F5 E1 | Control / electronics | Service |
| F6E2 | Whirlpool lists F6E2 as: control unit, user interface or wiring issue. Also: F6 E2 | Control / electronics | Service |
| F6E3 | Whirlpool lists F6E3 as: control unit, user interface or wiring issue. Also: F6 E3 | Control / electronics | Service |
| F7E2 | Whirlpool lists F7E2 as: control unit, user interface or wiring issue. Also: F7 E2 | Control / electronics | Service |
| F7E4 | Whirlpool lists F7E4 as: shifter issue. Also: F7 E4 | Control / electronics | Service |
| F7E7 | Whirlpool lists F7E7 as: control unit, user interface or wiring issue. Also: F7 E7 | Control / electronics | Service |
| F7E9 | Whirlpool lists F7E9 as: main router, user interface or wiring issue. Also: F7 E9 | Control / electronics | Service |
| Fd | Whirlpool lists Fd as: factory default settings restored (not an error). | Control / electronics | Service |
Symptoms
Sources
- Whirlpool Product Help: F0E0 - Error Code (official)
- Whirlpool Product Help: F0E2 - Error Code (official)
- Whirlpool Product Help: F0E3 - Error Code (official)
- Whirlpool Product Help: F0E4 - Error Code (official)
- Whirlpool Product Help: F0E5 - Error Code (official)
- Whirlpool Product Help: F0E7 - Error Code (official)
- Whirlpool Product Help: F0E8 - Error Code (official)
- Whirlpool Product Help: F0E9 - Error Code (official)
- Whirlpool Product Help: F1E1- Error Code (official)
- Whirlpool Product Help: F1E2- Error Code (official)
- Whirlpool Product Help: F2E1- Error Code (official)
- Whirlpool Product Help: F2E2 - Error Code (official)
- Whirlpool Product Help: F2E3 - Error Code (official)
- Whirlpool Product Help: F2E4 - Error Code (official)
- Whirlpool Product Help: F2E5 - Error Code (official)
- Whirlpool Product Help: F3E1 - Error Code (official)
- Whirlpool Product Help: F3E2 - Error Code (official)
- Whirlpool Product Help: F3E3 - Error Code (official)
- Whirlpool Product Help: F3E5 - Error Code (official)
- Whirlpool Product Help: F5E1 - Error Code (official)
- Whirlpool Product Help: F5E2 - Error Code (official)
- Whirlpool Product Help: F5E3 - Error Code (official)
- Whirlpool Product Help: F5E4 - Error Code (official)
- Whirlpool Product Help: F6E1 - Error Code (official)
- Whirlpool Product Help: F6E2 - Error Code (official)
- Whirlpool Product Help: F6E3 - Error Code (official)
- Whirlpool Product Help: F7E0 - Error Code (official)
- Whirlpool Product Help: F7E1 - Error Code (official)
- Whirlpool Product Help: F7E2 - Error Code (official)
- Whirlpool Product Help: F7E4 - Error Code (official)
- Whirlpool Product Help: F7E5 - Error Code (official)
- Whirlpool Product Help: F7E6 - Error Code (official)
- Whirlpool Product Help: F7E7 - Error Code (official)
- Whirlpool Product Help: F7E9 - Error Code (official)
- Whirlpool Product Help: F8E1 - Error Code (official)
- Whirlpool Product Help: F8E2 - Error Code (official)
- Whirlpool Product Help: F8E3 - Error Code (official)
- Whirlpool Product Help: F8E6 - Error Code (official)
- Whirlpool Product Help: F9E1 - Error Code (official)
- Whirlpool Product Help: Fd - Error Code (official)
- Whirlpool Product Help: HC - Error Code (official)
- Whirlpool Product Help: LF - Error Code (official)
- Whirlpool Product Help: LdL - Error Code (official)
- Whirlpool Product Help: LdU - Error Code (official)
- Whirlpool Product Help: Ld - Error Code (official)
- Whirlpool Product Help: Lid - Error Code (official)
- Whirlpool Product Help: OFb or ofb - Error Code (official)
- Whirlpool Product Help: PF - Error Code (official)
- Whirlpool Product Help: Sd or 5d - Error Code (official)
- Whirlpool Product Help: Sud - Error Code (official)
- Whirlpool Product Help: dLO - Error Code (official)
- Whirlpool Product Help: dU - Error Code (official)
- Whirlpool Product Help: drn - Error Code (official)
- Whirlpool Product Help: oL - Error Code (official)
- Whirlpool Product Help: uL - Error Code (official)
Last reviewed: October 20, 2026. ErrorCodePro is not affiliated with Whirlpool.